Reinforced Composite Facers for Rigid Foam Boards
A reinforced composite facer direction for PIR, PUR, XPS and polyiso boards. Review reinforcement structure, facing side, bonding or lamination, handling and board-process fit through route-specific data and samples; the facer alone does not establish finished-board strength or system performance.
Document availability
All listed document types: Available upon request
Documents are matched to the selected route, model, application and applicable report scope.
S15 product brief at a glance
Where this route fits best
Specification overview for route review
Technical review focus
Validation and document basis
How this route sits inside the buyer system
Layer stack is conceptual and must be adapted to the buyer final board construction.
Reinforced composite facer
Yarn, glass-tissue or glass-fabric reinforcement matched to the selected route.
Bonding / lamination interface
Validated with the buyer adhesive, foam or board-facing interface.
PIR/PUR/XPS/Polyiso board
Board construction and production process determine final selection.
Route review path before sampling
QCRP-R300-1000 Series is shared with S16 but this page is the Reinforced route. Selection is subject to sample and board-level validation.
Rigid-foam board manufacturers should compare reinforcement structure, handling, bonding or lamination and dimensional fit in the intended board process before selecting a route.
Models, material type and area weight need to match the selected board construction.
Document availability depends on selected route, model and construction scope.
Request-gated document status
Availability is confirmed by selected route, model, application scope and internal review.
Product Brief
Shared after the intended board application and selected route are reviewed.
Technical Data
Reviewed by selected model, construction and buyer-side application context.
Sample / Evaluation Guide
A4 samples or small rolls support material and board-level validation.
Compliance / Sustainability
Availability depends on selected route, declared scope and current verification context.
Is S15 a separate model series from S16?
No. Both use the QCRP-R300-1000 Series; they are differentiated by their structural route.
What confirms final suitability?
Sample and board-level validation of the selected construction, bonding interface and production process.
Review S15 for your board application
Share the proposed board system, selected facer direction and validation needs. GRECHO will coordinate the next review step according to the selected route.
